Visit our newest sister site!
Hundreds of free aircraft flight manuals
Civilian • Historical • Military • Declassified • FREE!


TUCoPS :: Radio :: ic32at2.txt

Modification for Icom 32at




IC32AT.2

                        OUT OF BAND MOD FOR THE IC-32AT

This mod allows the unit to RX-TX outside both ham bands, plus
function as a crossband repeater!  BE CAREFUL THAT YOU DON'T
INADVERTENTLY TRANSMIT!

DISASSEMBLY

1.  Remove the battery.
2.  Loosen but do not remove the two screws holding the PTT switch
    plate.
3.  Remove the 4 screws on the back of the radio.
4.  Now remove the front of the HT by carefully lifting the bottom
    edge and then pulling it down so it clears the top of the HT. Be
    carefull as there is a ribbon cable attached.
5.  Unplug the Speaker/Mic plug from the main chassis to allow the
    front conver to be fully opened.

MODIFICATION (Refer to figure 1.)

1.  Remove D907
2.  Remove D913.
3.  Move D912 down to next pad. (D???, bottom location)
4.  Add diodes Da and Db (1N914 or Equiv.).
CONTINUED IN FILE IC32AT.9
 


TUCoPS is optimized to look best in Firefox® on a widescreen monitor (1440x900 or better).
Site design & layout copyright © 1986-2014 AOH