Visit our newest sister site!
Hundreds of free aircraft flight manuals
Civilian • Historical • Military • Declassified • FREE!


TUCoPS :: Radio :: ic24at_3.txt

Mod for Icom 24at




IC24AT.3

 AM AIRCRAFT RECEIVE PLUS 740 to 960 MHz RECEIVE

 Remove D13 from the main logic board (this diode may already be
 removed by ICOM in some units).  This diode may already be
 removed in some radios.  D13 is on the main logic board and is a
 discreet diode (one of the two in the radio) near the center of
 the board.  It is the left discreet diode of the two on the board
 when the radio is open and held with the controls away from you.

 Simultaneously hold "Light", "B", and "#" keys depressed and turn
 power on.

 It is important to note that the radio will not meet specifica-
 tion on the out of band receive frequencies that are enabled with
 this modification.

 DIRECT KEYBOARD ENTRY of 100 MHz FREQUENCY

 Simultaneously hold "Light" and "3" keys depressed and turn power
 on.

 CROSS BAND REPEAT (simplex)

 Remove D14 from the main logic board (tiis diode may already be
 removed by ICOM in some units).  The diode is a discreet diode to
 the right of D13 (from above) and directly beside it.

 Simultaneously hold "Funct" depressed and push "C".

 To turn on cross band repeat:
 Hold "Funct" depressed then push "5" and then push "D".

 To turn off cross band repeat simultaneously hold "Funct" and "D"
 depressed.
%***********************
 NOTE: I haven't tested these, proceed at your own risk!  WA2ISE
------------------------
A notice found on a piece of test equipment made in Japan:
"IT PUT ON THE VINYL SHEET ON THE SURFACE OF UPPER & LOWER PANEL FOR THE
PROTECTION  PLEASE USE AFTER TEAR OFF VINYL SHEET WHEN USING.


TUCoPS is optimized to look best in Firefox® on a widescreen monitor (1440x900 or better).
Site design & layout copyright © 1986-2014 AOH